Jump to content

eddieb

Member
  • Content Count

    27
  • Joined

  • Last visited

Community Reputation

1 Neutral

About eddieb

  • Rank
    Member
  1. The problem is their shipping. I was going to bt 4 mags for $23.60. But they wanted $24.12 for shipping. Don't need the mags that bad
  2. Looks like your hammer is in backwards. I did the same thing on my first conversion.
  3. The UTG quadrail is not 922r compliant. I believe it's made in China. I may be wrong about that, but I do know that it is not made in the US.
  4. Come on guys. Somebody must have a picture of a reprofiled BHO.
  5. I've seen it mentioned about reprofiling the BHO lever so it doesn't get in the way when pulling the trigger. Anyone have a picture of a reprofiled BHO?
  6. I have a UTG quad rail on my 7.62 and it came with everything needed... +1 for the UTG quad rail. Good and solid, light weight. Plus the cost is reasonable. Only down side is that it's made in China, so if you were going to include the hand guard as a part for 922r compliance, you're out of luck. If you've done a full conversion though, you're good to go.
  7. I just finished my conversion today, using the same kit you got. I reused my Tapco T6 PG and stock, also. The PG need quite a bit of fitting to make it sit flush with the receiver. All in all, not a bad project. Worth the effort. You don't need anything else.
  8. You know, this conversion would have been done in just over an hour, if this dope would have thought it though. I put the hammer in backwards and couldn't for the life me, figure out why the hammer wouldn't reset. The bolt would hit the hammer, but the hammer would just pop up. Well after 4 hours, I decided to come to the forum and found a picture of a hammer being installed. Bingo! Turned the hammer around and all is working great.
  9. Very easy internet search. Not exactly mickey mouse agencies. As far as I can determine, no agency, except maybe the US Secret Service, has unlimited budgets. Feeding, penetration, energy, quick follow-up shots make it a great cartridge. # Alameda County # Delaware State Police (First to adopt the 357 SIG) # Dallas, Texas Police # Federal Air Marshals # Federal Protective Services (FPS) Special Agents for General Services Administration (GSA) - P229 # Keizer Police Department, Oregon # La Porte County Indiana Sheriff's Department # Laurence County Sheriff's Office, Tennessee # Las
  10. You're not serious , are you? No where near a novelty round. The Secret Service, many Federal agencies, state agencies, local law enforcement, etc. have transition to 357Sig. It ain't going anywhere. Improved feeding alone will keep it around.
  11. Sorry that I didn't respond sooner. What condition is it in?
×
×
  • Create New...