kindapointless

Anyone want to post me up a good side profile of a shotgun hammer? I remember my s12 hammer being different then the tapco and grinding it to the same profile. Trying to reduce some drag

I'm so in on any drum like that Mike. I love my lil 12 rounders unfortunately both the ones I have now seem to have too much spring pressure when full, i have to shove the bolt forward to even chamber the first one

Wow wish I would have seen this before I bought the spets at least these guys would answer the phone or reply to an email

Which red dot and how are you mounting it? Been looking for options and haven't really found anything too cool yet

Want soooooooo much especially that 21 rounder

I second the css 10 rounders. The small promag drum is okish but the css mags are a world of greatness

Its definitely folded up right at the trunion right there. Camming lug shows slight impact, bottom shell guide on the bolt opposite the extractor is looking beat on each side.

Something dosent seem to be fitting right, front part of the bolt is getting pretty beat up and the bolt pin is bent

I have a dph plug in it right now, ran 100 rounds though it today and I could get it out, the knurling on the dph is almost 3 times as high as the I'm guessing lynx plug. It's the pin not straight in the gas block that hangs it up. During my full teardown today I also noticed my gas block is off of a different gun. Evey other part is stamped 935 then the gas block is stamped 944

I always use high temp antisieze, grabbed a dph for the moment. Will probably go auto plug at some point once I get the rest of the gun worked over

Ah gotcha my last one was wayyyy earlier so that's why I remember it being short. Thank you

Wow not only did you find it you found it cheap. Barrel should be m22x.75 correct? Might as well grab the tap and die for that too from the same place.

It looks like it is at an angle. Kind of a redneck test but putting in the plug a couple a couple times when clean it looks like the lead thread on the gas plug gets folded over a tiny bit so I'm guessing its hitting the pin as it goes all the way in. New gas plug and a bit of thread chasing should fix it. After 300 slugs on position 1 (150 each range visit) gun is running ok but won't feed more then 5 rounds out of a magazine and dosent like the drums at all. Position 2 felt over gassed with same slugs. Guessing to much drag with mag tension. Dont want to smooth anything out till I

I dont remember my last one being set back this far and it seems to have a wave in it from being set back?