Jump to content

Kurlus

Member
  • Content Count

    7
  • Joined

  • Last visited

Community Reputation

1 Neutral

About Kurlus

  • Rank
    Newbie
  1. Just installed, adjusted and burned about 50 rounds thru it. Ran everything from the Federal 7 1/2 load to Remington Slugger 2 3/4 Rifled Slugs perfectly. It also greatly reduced the recoil of my overgased monster to a decent level. 50 rounds and my shoulder isn't bruised, I couldn't run 10 rounds before and say that. Think I'm in love, thanks for the help and the awesome product!
  2. Your ports are not at ten and two .... Your plug needs to be in the detent... your guns bolt is not moving because you have all the gas blocked off. When I took it off I noticed the notch for the detent, I screwed it too far down and yes to those who commented, my gun cycles crap ammo with the Factory Plug on Setting 1 and 2. It's highly overgased. I have to wait until the weekend to try the plug again. Thanks for the help!
  3. I'm having the same problem. My Saiga 12 (3 port) cycled Federal Value 7 1/2 on Factory Gas Plug Setting 1 and 2. I upgraded to the CSS plug and adjuster and everything was still fine. I installed the Auto plug this morning and ended up adjusting it all the way to the stops, when I fire the gun the bolt doesn't even move. Any ideas before I send this $50 POS back? Thanks fellas!
  4. Here's the first picture of my converted Saiga 12. I have 2 more modifications planned.
  5. Warpike, The lack of the forth coil may be your problem allowing some play in your BHO .
×
×
  • Create New...