Jump to content

Milmuseum

Member
  • Content Count

    14
  • Joined

  • Last visited

Community Reputation

1 Neutral

About Milmuseum

  • Rank
    Member

Profile Information

  • Gender
    Male
  • Location
    Brightwood OR
  • Interests
    Curator of the "Traveling Military Museum." Shooting old military guns in friendly competition.
  1. Thanks for the reply but the problem is that it quit working period. Adjusting does not seem to make any difference on low brass. FTE every round. It worked great at first. Hi brass has always worked in this gun but not low. I thought I finally had it fixed but was bummed when it quit working. Is there anything else I should add like a different puck? I,m almost ready to sell this despite the awsomeness it has when it works properly.
  2. Hi folks, it's been awhile since I've placed a post. I installed a TAC 47 auto plug in my converted S12. I adjusted it according to the instructions and it worked perfect with low brass for the first 75 rounds but Then went back to FTE. Thought it was just dirty so I cleaned it and went back out. This time low brass was FTE every shot, tried adjusting but no luck. Hi Brass works fine. Any ideas?
  3. Someone already did this last week. I saw it on The Blaze. It has the names and address of everyone involved in publishing the gun owners list:)
  4. Will leaving a 20rnd drum loaded for an extended time weaken the spring? The Beta C-Mags can be left loaded with no problems, are the ones for a Saiga 12 the same? Thanks
  5. Jun 1, 2011: Work Session held. Jun 13, 2011: Recommendation: Do pass with amendments to the A-Eng. bill. (Printed B-Eng.) <LI>Jun 14, 2011: Second reading. This is exellent news, A vote could happen any time Cross your fingers and call your Senators !!!
  6. http://gov.oregonlive.com/bill/2011/HB2792/ Still kickin, need to contact your reps now to keep this one going. The next step is to bring it to the floor for a vote.
  7. Here's the wife trying out my new build.
  8. http://gov.oregonlive.com/bill/2011/HB2792/ http://gov.oregonlive.com/bill/2011/HB2787/ I'm watching both these bills closley. Email your legislators and encourage them to vote yes on both. They won't do anything unless you make yourself heard. OFF Oregon has some great links to do this.
  9. It is to hold the bolt open. Pull the bolt to the rear and press up. Makes it much easier to insert magazines.
×
×
  • Create New...