am2fan

The few slugs and buck I ran through it cycled ok on 1 setting of gas plug. Low brass 8 shot would only cycle on 3 setting of plug. It seemed to be going ok then the events described above went on. It does not have low brass reliability kit, so springs are stock. Unless hammer comes profiled in the CSS build kits, this has not be done. Yeah Insp 12 I've already been seriously considering sending to JTE to be done with it. Unless y''all have additional suggestions ? Thanks

Thanks. I will try those things. Why run slugs thru though?

Haven't been on for awhile. I wanted to get any info or insight folks may have about the following concerns. I have 19" S12. I converted it using one of the CSS numbered kits. It has polymer forend and 6 position stock. The gas regulator is older style gun fixer -1/+1, 2, and 3. Puck is Tapco. Also has bolt with mirror finish polishing by Paulys. I modified gas ports by drilling to 3/32 and adding additional 1/16" port as one of the 3/32 ports was still partly blocked even after D modification to gas block. Prior to all things above the gun basically wouldn't run except for magnum buckshot and

OK Thanks

Could someone tell me the thread pitch on the screw used to hold forearm to bottom of gas blcok? Must have damaged edge of the threads when getting gas blcok off to do port job, so I need to tap/repair. Thanks

Yes - seems to be straight, ports drilled to .093 and all visible/uncovered now. Gas block polished, opening slightly enlarged. Got it back together. How about polishing burrs out of barrel where ports were enlarged? Best way? Thanks for the help

I searched archives but didn't find the answer or at least I didn't see it anywhere. I must have gotten in a hurry when removing gas block because I lost my witness mark ( I guess I didn't scribe deep enough) when re-installing after drilling ports and polishing. I think I have it aligned - got the bottom pin re-installed but had to wrap it pretty sharply with hammer and finish with drive pin punch. Is this normal? Is it possible to drive the pins in and not be aligned with the barrel pin slots? Don't want to mess this up - I'm ready to be done with the work and go shoot! Thanks