Jump to content

Brandino

Member
  • Content Count

    7
  • Joined

  • Last visited

Everything posted by Brandino

  1. <br /><br /><br /> It appears you and I are in the same exact boat... I have a new Saiga 12 with the same markings, from the same importer with the same problems. Have you gotten any information about fixing the ports and their refund policy?
  2. <br /><br /><br /> Should I looking into sending it off for warranty work 1st, or get someone to jump right in with the polish job?
  3. The stamp on the receiver is Legion Usa Inc. Hallandale, FL... I haven't had much luck finding a lot of info on them.
  4. <br /><br /><br /> Thank you everyone for trying to help me out!!! Good news is with the picture above from spaniel I was able to figure out where the placement of the holes should be. And I'm embarrassed to say I found (what I would consider) 2 1/2 holes. I am learning more about this firearm, so I may be mistaken, but I believe that one of the holes is almost completely blocked. I also noticed that the other 2 gas holes are incredibly small, is this normal? I shot the gun again yesterday after finding the holes and trying to free them of any trash with the paper
  5. Thank you for your reply... Sorry about the poor picture, that's the best I got
  6. Hello board, I have been reading this board a lot lately upon purchase of my new Saiga 12, but I have ran into problems. I am reluctant to ask my questions because they are very similar to those before... I am getting nothing but FTE's with my new shotgun. I 1st bought Winchester super target, when it FTE'd i figured it was similar to the "bulk pack" so I read on the Red Jacket website to see that Saiga cycles Winchester super handicap like a champ. The super handicap FTE'd, so then I ran some Remington buckshot (4 bk) with the same result. Today I tried to see if the ports were blocked a
×
×
  • Create New...