Jump to content

dmac27

Member
 View Profile  See their activity

  • Content Count

    120

  • Joined

  • Last visited

Community Reputation

17 Neutral

About dmac27

  • Rank
    Advanced Member
  1. dmac27
    I will be there.
  2. dmac27
    I put mine back in on my 7.62 and then left it out of my 5.45. I like them much better with out so I ended up taking it out of my 7.62. I almost never shoot at a range and it bothered my trigger finger.
  3. dmac27
    That's what I was thinking...although they do also make a 30.06 bolt action. I hope that is not what they were referring to.
  4. dmac27
    Check out this article especially near the end when they are quoting an Izhmash official. http://www.bbc.co.uk/news/world-europe-15076757
  5. dmac27
    That is the real thing... an East German AK-74 zig zag muzzle brake. Did you install a thread adapter on that rifle? Well, yes, of course . I had the barrel threaded to 14x1 LH and I installed a 14 to 1 LH to a 24 mm adapter because the zig zag brake is a 24 mm thread . It didn't look like it was that wide in the back from the pictures you posted. And if I offended you with my question it was...of course... unintentional. I thought maybe the Germans made a zig zag brake with 14 X 1 LH threads. I have a Bulgarian FSB on my 5.45 with a zig zag brake. And I thre
  6. dmac27
    That is the real thing... an East German AK-74 zig zag muzzle brake. Did you install a thread adapter on that rifle?
  7. dmac27
    Looks good...who makes the muzzle brake you have installed there?
  8. dmac27
    I think Dinzag carries them.
  9. dmac27
    I love my steel Polish mags...I couldn't even imagine using a 45 round mag. I think they are too long...
  10. dmac27
    Thank you
  11. dmac27
    Should the 5.45 have an 800 meter rear sight or a 1000 meter rear sight?
  12. dmac27
    Could you please post an example link of what it is that I need to get? Try Saiga-AK.com I bought one of his retainers for my first conversion and it fits as tight as a factory retainer.
  13. dmac27
    +1 This is the easiest way to go. If you want an actual hand guard retainer you have to remove the front sight base and the gas block.
  14. dmac27
    I have tried a screw driver with no luck...perhaps I will try again.
  15. dmac27
    Does anyone have one that would be willing to trace the outline of the tool and email it to me. I want to make my own tool out of O1 tool steel but am not sure of the size. My email address is mcn.donald@gmail.com
×
×
  • Create New...