manofmanytrades

With the pg flush against the triggerguard, the only thing keeping it from seating correctly and the holes lining up was the rear screw that holds the triggerguard down. I dremeled off the last 1/4" of the bracket with the screw and spot welded it to the gun instead, fits great now. Thanks for all the suggestions.

I am converting my saiga 308 to pistol grip, and installed one of Dinzag's trigger groups with trigger guard. I bought an "engage AK pistol grip" to install, and found that there is a 1/2" gap between the trigger guard and pistol grip centered over its screw hole. If I move the pistol grip to touch the trigger guard where it's supposed to be, then I'd have to cut out the entire back of the pistol grip because it literally wont fit otherwise. Even if I did this the bolt mounting hole still wouldnt line up. Ive attached two photos to show what I mean... Does the 308 require a special AK pis

I realize that there are other posts on this topic, but I was hoping for a direct comparison of these products: I have a saiga 308 that i want to mount an M4 Aimpoint on. I would like it to mount low enough that i can get a good cheek weld on the stock, or at least add a cheek pad to the stock to make it possible. Finally, it need to be able to hold a zero after removal. The only mounts that i can find that fit the meet these requirements are the Texas Weapon System dog leg rail, the Krebs rear rail system, and the Ultimak scout mount. From what i understand, the Ultimak might not fit