Jump to content

Ruly3

Contributor
  • Content Count

    7
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Ruly3

  • Rank
    Newbie
  • Birthday 08/25/1971

Profile Information

  • Gender
    Male
  • Location
    Chandler, Arizona U.S.A.
  1. Thanks... I followed the instructions that Pauly provided above. Relatively easy job...now to test.
  2. I have a Saiga-12 3-port. I want to elliminate friction as much as possible. I have a polished Bolt/Carrier/Tigger/etc by Pauly (Awesome job). Can someone recommend/describe how to go about polishing the rails? Exactly where? What to use? Mirror polished or leave "brushed". Pictures help a lot too! Much appreciated...
  3. So my Saiga-12 is back together tonight after all the drilling and filing. I cleanned up to bare metal the surfaces where the gas block presses on to the barrell, sprayed some Rem oil on it and used a 2" nylon mallet to tap the gas block back in (without the puck/plug installed)... that was easy. Now I need to get it to the range a test fire some cheap Winchester Universal 7 1/2 shot. Thanks everyone! I'll report back soon with the results...
  4. OK...I disassembled everything...took off the gas block... I confirmed 3 ports only mesuring .07. I re-drilled all three with a 3/32 bit to .093. I also enlaged the porthole in the gas block with some jewelers files because one or the barrel ports was obstructed just barely at .07 and most definetly would be at .093. So now I'm curious on recomendations to reinstall the gas block...should I tap it in with a chisel again similar how it was suggested to remove it?
  5. I'm progressing with my Saiga-12 build, but still unable to cycle low brass...every shell (Winchester Universal 7 1/2 shot) results in an FTE. I have Pauly's Glass Bolt and Ice Rack Supreme. I have a CSS puck and a TAC-47 Autoplug. Forward tigger group, etc. Everything is well lubed and installed. Still can't cycle low brass. My Saiga-12 has 3 ports and I am able to check the diameter with the Pauly's wire guages. The .07 slides right in all 3 ports with a tiny, tiny bit of play... the .08 dosen't fit. I thought I read somewhere on this forum that my 3 ports should be .09. If tha
×
×
  • Create New...