Jump to content

Bodam

Member
  • Content Count

    32
  • Joined

  • Last visited

Community Reputation

9 Neutral

About Bodam

  • Rank
    Member

Profile Information

  • Gender
    Male
  • Location
    Cypress, TX
  1. I want a free conversion too! AND I'm local, lol!!! Spent the day out back chillin by the pool, trying to relax
  2. jeesh, I just bought an XD, wish I knew you were selling. How much you want for it, and where are you?
  3. Bodam

    Texas?

    A meet on some property in the Houston area would be great. Maybe a pit? Someone step up. I don't own property or this would already have been done!
  4. LWD said to ship it back and they will check it out. I'd like to see if it's a mag issue, etc. I want to shoot it and log what is going on.
  5. I'll take some pics of the barrel tonight. Funny thing is, last night I tried all three mags, and three diff kinds of ammo. And they all cycled by hand. It still leaves scratches on the brass, but it cycles. I'm going to mark the brass and see where the scratches are coming from. I'm a big fan of Glock, but you are right, this new pistol is wearing me out.
  6. The funny thing is, MIddleboro isn't the "typical" Mass town. We used to make fun of them for being redneck, lol. Then I move to TX...lol
  7. I visited the store last weekend. A lot of cool Saiga stuff
  8. Well went home last night to put the new barrel in, and factory ammo will not feed. The barrel drops right in. When I cycle the slide, the first round jams diagonally, leaving vertical scratches on the brass. The factory barrel feeds properly. Can't figure out where the ammo is catching. So after I had to send the damn Glock in, now I have to send the barrel back to Lone Wolf.
  9. Got my Wolf at a local gun show for $115. I'll post up a review once I get to the range.
  10. yeah, Lone Wolf. I hope it's decent. Gotta be an upgrade at least. And hopefully safer with the lead
  11. I use a Lee Loadmaster, which uses the disc. It's pretty hard to over charge a round, but not impossible. I spot check by weight to make sure it is consistent with powder charge. I did not use magnum primers. Most people that I show the brass to, think it was bad brass, since it came apart down at the base ring. I will never know for sure, but I bought an aftermarket barrel to be safe.
  12. Lol, my wife went to HIgh School in MIddleboro. We don't miss Mass a friggin bit
  13. Just to update: Sent it to Glock and just got it back yesterday. Only about a two week turnaround. No charge for a new extractor, and full inspection. Pretty damn good service from Glock I must say. Now I have a new barrel, and I'm ready to try her out again....
×
×
  • Create New...