-
Content Count
43 -
Joined
-
Last visited
Community Reputation
1 NeutralAbout Venomous
-
Rank
Member
- Birthday 02/01/1964
Contact Methods
-
Website URL
http://www.eyecit.net
Profile Information
-
Gender
Male
-
Location
Sunrise, FL.
-
Any idea what kind of choke that adapter would be like? Full Choke??
-
The Hand Guard is pretty light since the top rail is plastic. I think the three rails I added were heavier than the hand guard..lol
-
No, If you look at the factory rod when you remove the hand guard you will notice the factory rod is longer after the cup nut for no reason. Salem 6 took out the extra length that looks like it is only there for mounting the factory hand guard.
-
Ok, it took me much longer than expected to complete the Salem 6 hand Guard install with full length rails. I ran into two problems during the install that were no fault of Salem 6 but the fault of the manufacturers never ending design and spec changes from gun to gun. I have a pre XN model MKA-1919. I took out the guide rod using a stud remover and that worked great. The first problem was that the Salem 6 Rear Mounting plate has a small alignment pin that goes into the MKA receiver. The problem was the MKA receiver had no more then a dimple where a hole needed to be. I brought the receiver ou
-
Just went to the web site. Are the pre bent levers there? I see the drive block I need. Also another question. What length are the top and bottom rails on the shorty hand guard?
-
Is that the Mako recoil reducing stock? If so, how do you like it? I've been thinking about picking one up. Yes, it is the Mako Recoil reducing stock. I have not shot with it yet. But friends told me they have it on other guns and love it. It is a little on the heavy side.With all the mods my MKA is no longer light..... I also have the ATI Scorpion recoil reducing grip on it. It will be interesting to see how they work together.
-
Getting closer to being done...
-
Firebird lower installed. Gun is almost done , but not quite. Waiting on Hand Guard Rails and then will decide on sights. UTG Folding Mechanism is complete crap. Waiting on one part, then will swap the UTG out for a great folding mechanism.
-
Here is the rear of the lower.
-
Absolutely Beautiful... #6 will make it to me on Tuesday... Can't wait....
-
I have been trying to find 9" rails to fit this hand guard. The only ones I can find are the DiamondHead VRS 9" Rail Kit. But. they are sold out everywhere. I emailed the company and asked if they were flat on the bottom and when they would be available. They responded with all kinds of information except for the two questions I asked. Anybody familiar with these rails or have any ideas where to get 9" rails to go around the Salem 6 hand Guard?
-
Got my call and invoice from Nanci today. It should ship out tomorrow.
-
I think tooth and nail had a video where he removed it with an automotive tool. I will look for the video. Here is the video. What you want starts at about 4:25....
-
#6 on the list. Nanci says she will be calling next week for payment.
-
Trying to find 3 - 9" rails for this hand guard. I can find them.... But they are all sold out.....