Jump to content

Stretch1100

Member
  • Content Count

    15
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Stretch1100

  • Rank
    Member

Profile Information

  • Gender
    Male
  1. The flat side has the knurl so tap from the other side as you'll see the pins have a slight point to them.
  2. Cutting it is the easy part. It's getting it to fit right that can be a challenge. I cut mine with a hacksaw and then used a sander to get it down to the correct length as you don't want to cut to much off in your first cut otherwise you'll be screwed. I then had to use a dremel to trim the inside of the stock and a bit of the inside of the adaptor.
  3. Tooth, Can you post a pic of the side of the adaptor the goes inside the stock? I assume you include a new shorter bolt?
  4. Are you going to be making a charging handle to replace the factor one on the MKA?

  5. Where can one find out about the locations of 3 gun events? I'm in IL and I'd like to give it a try.
  6. Factory 10 rounders have worked flawlessly so far!
  7. Firebird said the are redesigning the charging handle part and to keep an eye on their Facebook page for announcements. Maybe a month or so. They aren't stocking the original one anymore.
  8. No but I'm a first timer and I got it gone. Challenging? Yes! Can you do it? Yes! Take your time and most importantly don't cut off to much the first time! You can always trim/sand/cut/grind it down more.
  9. I was told by Centerfire a few days ago that they've never actually had them in stock and have no eta. I emailed FB and they haven't responded. May have to go with the Salem6 one if that ever comes out.
×
×
  • Create New...