Jump to content

Tripleduece

Member
  • Content Count

    25
  • Joined

  • Last visited

Community Reputation

4 Neutral

About Tripleduece

  • Rank
    Member
  1. All have shipped... CSS is quickest. I am in sc too though.lol Everything is tough right now. My wife works for a large ar15 manufacture here and I still have a hard time getting stuff!! Haha they will come!
  2. Adjc, They had been on order for a hot minute! Had a 12 and a few tens. The rest I got from sgm as an atlantic b.o. and from CSS.
  3. Might be the shells. I have the same problem with my duplexes* shells but not others so far. The brass is really long on those though.
  4. For me I had to take a little meat off the mags for the follower to not get stuck as my magwell/recover opening was putting to much pressure on the mag. As far as them not locking. If you give the mag a tap till it locks you will see where the gun is hitting the mag in the cut out recessed area in the middle of the mag. Give it a little bevel love with some sand paper. I did this several times with 240 untill my mags went in easier yet still positively locked with no play. Then cleaned up with 360/600/1500 sand paper. By the time you get done with the 1500 it almost looks like they came out of
  5. I saw one thread about a sbs vepr but can't seem to find it. What is the shortest barreled vepr that is cycling properly with the gas block in the stock position and the stock gas ports? I LOVE my vepr... It's just too dang long! Lol
  6. I saw one thread about a sbs vepr but can't seem to find it. What is the shortest barreled vepr that is cycling properly with the gas block in the stock position and the stock gas ports? I LOVE my vepr... It's just too dang long! Lol
  7. I saw one thread about a sbs vepr but can't seem to find it. What is the shortest barreled vepr that is cycling properly with the gas block in the stock position and the stock gas ports? I LOVE my vepr... It's just too dang long! Lol
  8. I saw one thread about a sbs vepr but can't seem to find it. What is the shortest barreled vepr that is cycling properly with the gas block in the stock position and the stock gas ports? I LOVE my vepr... It's just too dang long! Lol
  9. +1 on the Molot brake. I had another companies and liked it...I really went to the molot (carolina's) and woah! tamed slugs like crazy!
  10. Pauly, with your setup will it still tak the vepr mags too?
  11. Just got the remainder of my order yesterday from Mississippi! Merry Christmas! Lol
×
×
  • Create New...