Jump to content

maverick143

Member
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

About maverick143

  • Rank
    Newbie
  1. I took the balck plate off of the drum and blew out some crap that was in there but wasn't sure how to get the wedge piece out without taking the metal piece out that holds the shells to check the 3 full turns? how do I get that piece out? by taking the metal clip off of the center rod? will it unwind on me if I that that piece out? Thanks Mark
  2. Thanks, I will try to do exactly like you say. What if it came with three full turns of tension? Then just make sure its clean? Mark
  3. Im having the same problem with low brass shells on the number 2 gas setting?
  4. I am having trouble getting my MD arms 20 rd drum to feed low brass shells. It feeds high brass just fine. I have changed the setting and still no luck. Low brass feeds fine out of factory 5 rd mag and 12 rd stick mags? It fits fine. It also will feed about 5-7 low brass rds out of the drum but not a full 19 rounds in the drum. it fires one at a time with drum full of low brass shells? Any Help? It was purchased in a lot of three and the other two work fine with all low brass low power shells?
×
×
  • Create New...