Onetap

U can also just take the safety lever off the gun and shave down the notch...ez fix

This is the greatest thing that has ever happened to me (:tear:)! Now gimme a damn drum mag nowwwww

Same girl same v12:

Well i put these on the other forum and lived to tell the tale so I guess i might as well throw em up here:

"tanya" is katie holmes in russian! Btw that is an incredibly sexy rig! My kingdom for that gk01

Any1 have any insight on which/if any of the saiga couplers will work with factory v12 mags?

I wish someone would make a coupler for em...although i guess it wouldnt be super hard to just fabricate yourself

Bring on the 10 rounders for $40!!!

The bolt carrier rails (in the receiver AND on the actual carrier) with emory cloth, 1000 grit sandpaper, and a little bit of oil...buffed with a knockoff dremel, took all of a half hour. Next step for me is sending it off for the robar np3 coating! If u guys havent checked them out you should, ive heard nothing but good things

Lol

Anybody else notice my gf shot 11 rounds out of the 10 round mag (nothing in the pipe)? Ive heard of 10 round saiga mags fitting 11 rounds but i didnt know the sgm's did that..

Edit: that video was the game loads...not 00

Lol dont you dare tell her that! I about died when i seen that thing climb on her...to her credit it was 3" 00buck though

Annnnd the gf with some 00buck:

Happy to report that a wee bit of polishing did the trick apparently! I present to you, Remington game loads 1290 fps unfaltered!!!

Yea that was the first thing i thought also. I did quite a bit of research b4 buying this weapon and tht seemed to be a recurring theme amongst the ppl having "issues" with the gun so i made sure i wasnt limping it at all. I think my next plan of action will be to polish the bolt carrier rails and see if that garners any results....other than that imma just run the hell out of some heavy loads. Im quite sure its something simple

That sounds about right. Thx all for the feedback, glad this isnt contributing to my fte issues...back to the drawing board for me

U never go full retard

Your new grip SHOULD come with it (the grip nut was the "block" i was referring to that lays inside the receiver). If it doesnt come with it you should be able to use the existing hardware granted you dont have one of those bastard staked screws that grt stripped out. When i replaced my grip i tried to reinsert thr factory screw into the fctory Your new grip SHOULD come with it (the grip nut was the "block" i was referring to that lays inside the receiver). If it doesnt come with it you should be able to use the existing hardware granted you dont have one of those bastard staked screws that

Actually just got through installing an ati scorpion grip on mine! Pretty straightforward though...that is, if the hogue is anything like the ati. Grab a big flathead screwdriver Twist the crap outta the screw on the bottom of the grip (ive read quite a few horror stories about the staked screw but mine wasnt an issue at all) Pop the dustcover Remove the spring Replace the block inside te receiver (if your new hardware came with a replacement...not a big deal either way) Reverse the process to install being careful to not over torque amd strip the screw Oh yea...your new grip should co

Yea mine did that...just posted the problem on here about a week ago. All the guys helped out alot, check out te thread "vepr 12 problem?"

Im no gunsmith or engineer or nothing like that but just visually judging by the internals design i figure the tip of the gas piston inserts into the cavity inside the puck once a round is chambered...gotta be tough with 1cm worth of play in the actual piston

Here it is

Am i allowed to post a youtube link? Or how would i go About posting a video?