Jump to content

J R

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About J R

  • Rank
    Newbie
  1. Thanks chileRelleno, The ports are about a !/8 inch not ¼ inch, DA on me! I have a gas port on the left side right on what I would call the gas block and it slants down Looks like nothing has come out of it because when I swobbed it it was clean. What is that actually for, to release gas? I Can stick a pipe cleaner through both holes and see it in the barrel. If I remember right, on these Sagas you have to heat the front and rear of the gas tube block to remove it, am I right? Thanks for your help in this. These type guns get to me. I mostly work on bolt guns, changing barrels out and porting or threading and re-bluing. I do a lot of revolver work for people who do quick draw and horse riding, shooting. I took this in because he was a friend and he bought it from a pawn shop. got 4 long mags, 4 short mags, laser, red dot sight. He paid $1000.00 for it. This thing shoots 3 inch mags real good and slugs, plus buckshot, all of them will eject properly. Thanks J. R.
  2. Yes 3 inch mag shoots good even buck shot. I did shoot one slug through it and it went and ejected fine. 2 pass ports looks like just under ¼ inch each. Factory gas plug in it too.
  3. Hello I am new to this site. I have worked on a couple of these 12 gauge shotguns but this one is getting to me. I can shoot 12 mags in this with no problem but when I try anything else it will not eject or it stove pipes, again mags shoot great and eject. I have turned the gas buffer to every number, made sure the acc. screw on the rail is sealed with blue lock tite, I have taken it apart and put a camera down in there and it is clean. I did see where some one cut the front spring but counted the coils and they only cut one coil off. Again I have used all sorts of ammo I even shot an old Winchester 12 gauge shell that is brass and it still would not eject. All the mags do eject. Could the piston be wore and if it is where can I get one? Could I make one if it's not metric thread? Any suggestions would help. You can email me at jrniblett@yahoo.com Thanks, J.R.
×
×
  • Create New...