Wildblue

All that says is she didn't talk to Obama, not that they would not do it. I don't believe anything they say.

If you don't have your Saiga and hicap mags now, get them soon. http://abcnews.go.com/Politics/story?id=6960824&page=1

With the Saiga .308, the factory FCG can be removed without drilling. Just disengage the retaining wire and push the pins out. Once the factory FCG is removed, look for the PG nut hole from the inside. It may or may not be there, but it is much easier to tell looking from the inside with the factory trigger removed. If the PG nut is not there, you will have to cut it yourself, or you can use the special trigger guard from SaigaTech. Removing the bottom plate is simply a matter of grinding/drilling spot-welds/rivets and popping the plate off with a small cold chisel. For a replaceme

With the Saiga .308, the factory FCG can be removed without drilling. Just disengage the retaining wire and push the pins out. Once the factory FCG is removed, look for the PG nut hole from the inside. It may or may not be there, but it is much easier to tell looking from the inside with the factory trigger removed. If the PG nut is not there, you will have to cut it yourself, or you can use the special trigger guard from SaigaTech. Removing the bottom plate is simply a matter of grinding/drilling spot-welds/rivets and popping the plate off with a small cold chisel. For a replaceme

http://www.komonews.com/news/offbeat/39095162.html

Which one goes on a S .308? http://www.ultimak.com/BuyAK.htm

http://www.mississippiautoarms.com/index.p...products_id=357 If so would you do it again? I want to mount something like this. Any advice? http://www.opticsplanet.net/leatherwood-hi...t-es1x50tp.html

I've searched the forum for Saiga .308 FCG information and I want to get confirmation on a few things. First, if I get the $85 RSA adjustable FCG for the VEPR .308, will it be a drop in install with no drilling, grinding, etc? Any other "plug and play" FCG suggestions? Tromix? Second, will standard TAPCO AK Trigger/Hammer Axis-Pin Retaining Plate work in the S.308? Last, what is the best solution for retaining the pins? I already have Surefire mags and an M4 stock kit.

You can't go wrong with RCBS. I've have the same equipment for over 30 years. Everything you need is right here: http://www.rcbs.com/

I'm picking up my new 16" Saiga .308 tomorrow! I use to have a nice M1A1 but I got away from shooting and reloading for a while and a friend of mine really wanted it so I sold it to him. I have a ton of .308 ammo and brass for reloading so the Saiga .308 was an obvious choice for me. I intend to get some hi-cap mags and and M4 stock. I also have a 30.06, a 22-250, .222, 357mag, 38 spl. and a new Kahr PM 9mm for my CCW.