jtrimble7

Who has the best deal now on 19" Saiga 12's ? Thanks

Thanks for all the help guys. Heres what I did: 1. Lubed the drum 2. Polished the pieces where friction was occuring 3. Broke the drum in by leaving it loaded for a few days and pushed some shells in and out. Thanks

Hi What is a good Dremel Tool bit to use for polishing the Bolt Carrier, Hammer, etc. Thanks

Thanks for all the help guys. I'm doing the break-in thing and will try it soon. I found another issue while cleaning my gun today. There is quite a bit of friction between the bolt carrier and the hammer as it cycles. I actually have to find a way to hold the hammer down to re-assemble after cleaning. This could be causing other problems too. I read somewhere about "polishing" the bottom of the bolt trigger and the bolt carrier. How is this done ? I have a dremel tool. How much should I take off and how much should those parts be rubbing in a well functioning gun ? Thanks Again.

CORRECTION: it was Estate 2 3/4" shells I was using. Thanks

Hi Guys: Took my new drum to the range yesterday using 2 1/2" Federal #4 Buckshot with regular brass. Would not feed with the drum fully loaded. I then put 6 of the same shells in a 10 round mag and it worked fine. I then put 5 of the same shells into the drum and that also worked fine. Is the spring tension too tight - it works with 5 rounds but not 20 loaded in the drum ? I have read about other solutions ( new gas plug, polishing parts, etc). I had the gas plug set to 1 according to instructions. Any help would be appreciated. Thanks.

Hi Again Guys I ahve ordered my vented polychoke and sights. I just need to know if this rail: http://www.blackjackbuffers.com/index.php?...=20a&page=4 The "Picattiny Rail - Short Length" will work and if so, do I need special hardware ? Thanks in advane for the help, everyone has been great.

start here: http://www.msautoarms.com/index.php?main_p...f49431620a4c592 Tromix parts are some of the best for the S12 and Mississippi auto Arms is the place to get them. you can also check out RedStar Arms, BlackJack Buffers, and Dinzag Arms. that'll get you started. you can find out a lot by going to the "Items for Sale from Business Members" too. And you can check out the picture thread in this part of the forum (sticky thread at the top) for pictures to give you ideas oops . . .almost forgot . . .for the sights, put in an order with Krebs Customs http://www.krebscustom.com/

WTB - Fore end rail or modified fore end, front grip, screw on ak-type sight, 10 round mags. Thanks

Hi - I'm new so forgive what is probably a dumb question. I just got a S 12. I want to get a flash supressor or muzzle break, AK-type sight and a rig for a grip on the forearm ? Anything available or am I SOL ? Thanks

Go on gunbroker.com. You may pay a little more but they are available.

Thanks for your response. How about the Poly Choke ? I've heard conflicting reports - some say it wont install properly on new Saiga 12's, or that it dosnt work right and make the gun unbalanced. I appreciate the info.

Hi Guys I'm new to the forum. What does the above item do, and how does it install ? Is it worth it ? Also, has anyone used the Chaos Muzzle break ? Thanks