emr454

I'm not looking to spend $100 or more for a trunnion, looks like Arms of America is the best bet. Thanks.

Looking for an AK47 front trunnion

PM sent

Looking for factory trigger group (trigger, yoke, disconnector/trigger hook) from a 7.62x39 Saiga.

I was hoping to find someone nearby to help out/guide me through re-building the receiver. So far I've got all the receiver parts but im missing the barrel, etc. At the least I'd like to get the trunnions riveted in.

Bump...

Nobody?

Still looking to build a compliant AK if anyone can help...

Bueller?

Happy new year to you, Mike! Alternatively, is there anyone in CNY that has experience with bead blasting firearm parts? That would allow me to use one of the rattle can firearm finishes with better results. Eric

I've got a few small parts that I want to have Duracoated/Cerakoated. Prior experience has proven that I am incapable of finishing gun parts. I know there are a few CNY members here, and if you're willing to do some finish work I'll make it worth your while. Mainly I need a PF9 slide refinished. Eric

Still looking for parts, namely barrel, bolt, carrier, gas tube, RSB, GB, FSB

Oh, I don't know. I guess it depends on the condition of the barrel. $200 maybe? I wouldn't be bothered if it didn't have furniture either. I've already got a lower hg. Having both sight blocks, gas block, and gas tube are the most important for me right now. Let me know what they say.

I used the bolt at the rear of the trigger guard to hold it in, much like your washer pic. However when I did my conversion, I drilled the hole for the rear of the trigger guard a little too far forward, and I couldn't get a washer in there. I could easily make one out of sheet metal though. Eric

I just did this mod today to my 7.62 and S-12, but used a piece of .060" kydex I had laying around. So far so good. May or may not replace them with washers or a sheet metal square. Eric

Just ordered a bunch of small parts, but still need complete barrel assembly, bolt and carrier.

Looking for 7.62x39 AK parts kit and/or individual parts. FCG, trunnions, gas tube, bolt/carrier, etc.

Story of my life, HA! I appreciate the offer for help. I'll get back to you once I have all the parts I need.

Sweet! Now I need to get the rest of the parts. Do you or anyone you know do build parties? I have no AK building tools and I'm really starting from scratch on this one

I got this Saiga receiver in a trade a few years ago and just found it again today. Not sure why someone would hack up a Saiga though? Anyway, when the front and rear trunnions were removed, the rivets weren't drilled on center, so some of the holes in the receiver are slightly out of round now. It doesn't appear that anything else on the receiver is messed with, so I was wondering if the holes can be welded and re-drilled? I've attached a few pics of the receiver, below. Anyone in the CNY area that has experience welding on guns/receivers? I'm about 30 minutes east of Syracuse and I w

Sweet! I don't know for sure on interchangeability between 7.62 and 5.45, but I'd be willing to try it. Thanks man

Damn. I'm always a day late it seems There's got to be someone out there that just did a conversion and could care less about the BHO

Looking for a 7.62x39 Saiga bolt hold open and spring