Search the Community
Showing results for tags 'dent'.
Found 2 results
-
Since the topic of my other thread was about drilling the gas ports, I felt this topic deserved it's own thread to hopefully make it easier to find for other users should they encounter an issue like mine. Replacing the Saiga 12 barrel is an expensive process and I've found that very few people would be comfortable even attempting it regardless of their fee. Hopefully this will prove valuable to someone in the future. In the process of hammering out the lower dowel pin to remove my gas block to drill the gas ports, I dented my barrel. While the bottom dowel pin was still installed, I wa
-
I haven't tested this out yet but it seems like it should work and it doesn't look really cheesy or backyard mechanic ish. Just went down to the auto parts store asked for a small diameter piece of vacuum line. since I only asked for about 5 inches of the stuff they let me have it for free. Only other thing needed is some super glue and about 5 mins. I cut off about 2.5 inches of the line, ran my pocket knife through one side of the vacuum line, put a small amount of superglue on the edge of the dust cover that needed to be covered. Then I slid the sliced piece of vac. line in place
