Search the Community
Showing results for tags '.410'.
Found 3 results
I apologize in advance for the lengthy post. I'm a Saiga newbie and trying really hard to not become frustrated on the ammo front. I'm looking for current advice on 3" ammo for my lightly used Saiga .410. For my rig, I have: Two 15-rd 3" SureFire Gun magazines One 30-rd ProMag 3" Drum that works well One 4-rd 3" factory magazine I had a heavy handful of 3" Remington and Winchester game loads and I burned through them verifying the weapon and all the mags worked properly. Everything worked well, with the gas setting on 1. So lately I've been searching for .410 shells from online retailers (local shops don't carry hardly any 3"). And I've scoured most of the posts here for research, but the info is scattered, inconsistent, and much of it is several years old. So here are my questions that, hopefully, someone with a .410 can advise me on: 1) Best ammos Does anyone have 3" shell recommendations for: - steel shot (game/target) - buckshot - "plinking" - slugs - And what's the final word on Winchester PDX1? 2) Best 3" .410 retailers I've been searching all the regulars (AmmoToGo, Midway, Cabela's, Sportsman's Guide, CheaperThanDirt, BulkAmmo, Natchez) none of them have a terrific selection of 3" in-stock. And I'm SHOCKED at how expensive .410 has become. Who's your go-to? 3) The 2-1/2" shell dilemma With my hardware, will they work? Can they work? Do any specific shells work? I ordered a case of cheaper Italian (B&P) game loads for low-cost shooting just as I get a feel for the weapon, and wouldn't you know it, the things won't feed properly. It seems the diameter of the brass is too wide (yes, wide) to consistently slide into the chamber with a manual cycle. I'm running a 75% failure-to-feed rate with them. The shells are also too long for the 15-rd mags (they measure a full 2.75" crimped). The drum took them, but roughly 1 in 3 won't even fully slide in the chamber from a manual cycle. I've complained to Natchez and to B&P, but I'm not holding my breath for a refund. I also made a foolish error and accidentally ordered a case of 2-1/2" Winchester PDX1 shells instead of 3". Is there any hope for me making use of these? Or am I SOL? I'd be willing to buy 2-1/2" mags (if I can find them), but aren't even sure they'd work with my weapon or with PDX1 shells. After the PDX1 mishap and the bunk Italian shells, I'm gun shy (pardon the pun) and can't afford to lose any more coin to shells that won't work. I never thought the ammo side could be so frustrating. I really was excited about finally getting a Saiga .410; but with all the ammo mishaps and risks of losing even more money, the whole experience has become a real buzzkill. Many thanks in advance for your guidance and expertise.
Hi all, Total newbie here. Anyone have suggestions for a magazine loader for my .410 mags and drum? I tried loading my new Saiga .410 15-rd magazines and 30-rd drum by hand and it didn't go particularly well. Got the mags loaded to 12 and had to quit. Drum only took 10 before it wouldn't load anymore, at least not easily. Any direction or suggestions would be greatly appreciated. Search didn't yield any particularly relevant threads so I'm starting new. Sorry if it's been covered. Would appreciate any links if I'm oblivious. Thanks.
I am trying my darndest to get my hands on one SGM 10 Round mag for my .410. If anyone can point me in the right direction or is willing to sell me one. I have a confirmed Paypal account and can pay immediately. Thanks in advance! DM