Search the Community
Showing results for tags 'pins'.
Found 2 results
I bought an internal stock adapter from dph, and grinding off the tang is simple enough, but directly above my pistol grip there are two pins riveted in. They are in the spot where I'm supposed to screw the adapter into the reciever. I can't take the pins out because one of them is holding a small skinny spring that travels the length of the reciever on the left hand side. What am I supposed to do? All the instruction videos just say cut off the tang, but don't mention these pins.
Somewhere I read someones post about pinning the FSB on, and they recommended "sighting it in" first, at the range, then marking it and pinning it in place. Kinda like bore sighting a scope I guess. I can't find the thread, but had a question about it. Was that only for a saiga that originally had a pressed on sight, where you have to drill pin holes yourself? My factory FSB was pinned, so it already has holes, so am I correct in assuming that i'm not gonna be able to budge it from where the pin holes are anyway so might as well pin the new one where the pins line up, and just drift the windage to correct for any slight cant it could end up with ?