Jump to content
Sign in to follow this  
faststang90

if anyone knows russian

Recommended Posts

Looks like magazine fitting instructions, thats just a guess though. Did the mag fit/lock up well?

Edited by Veprz

Share this post


Link to post
Share on other sites

Google translate result.

 

INSTRUCTION for adjustment to products "Saiga - 410", "Saiga - 20", "Site - 12" 1. Install the store on the product. d. check the operation of the latch of the MAPAZIN: under the influence of its spine the rear magazine of the spring it must pass under the support surface of the hook until it stops in the rear surface B of the wall of the Mara. 3. In case of failure of the latch to the surface B, blacken the surface A with a simple pencil and cut it with a flat file until the traces of the pencil are removed, without covering the plane. For the file, firstly, attach the file to the entire surface, then do not tear it from the surface and lightly press it to it, in one movement, move 4-5 cm, removing the layer of material. Inspect the surface for the presence and location of traces of the pencil, if any, repeat until removed. Again check the work of the latch - n. 2. In case of failure to repeat the action under para. 3. 4. Do not get the appearance of a vertical backlash of Mara3Ha in the product.

  • Like 1

Share this post


Link to post
Share on other sites

Looks like magazine fitting instructions, thats just a guess though. Did the mag fit/lock up well?

no they fit and load the shells good.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×