saigafreake 27 Posted October 14, 2018 Report Share Posted October 14, 2018 can't find out any info on this saiga12 model has a cantilever dust cover factory front sight and a sleeve pressed on anybody have info thanks in advance. Quote Link to post Share on other sites
saigafreake 27 Posted October 16, 2018 Author Report Share Posted October 16, 2018 Didn't know this forum was so dead these days is there a new forum. Quote Link to post Share on other sites
evlblkwpnz 3,418 Posted October 16, 2018 Report Share Posted October 16, 2018 Looks like an IZ-433 or 030 series. I am not sure what is going on with that sleeve. Does the finish on the barrel match the receiver? If not, someone may have done some 'work' that required that sleeve-like portion. Look through the bore and see if there is a break in the bore at that point. It looks a lot like a barrel extension. Quote Link to post Share on other sites
saigafreake 27 Posted October 16, 2018 Author Report Share Posted October 16, 2018 Sleeve is factory as far as I can tell. has a notch on the bottom like a pin would sit on possible it had a very long handguard on it? Quote Link to post Share on other sites
Mullet Man 2,114 Posted October 17, 2018 Report Share Posted October 17, 2018 (edited) Someone removed a mid barrel comp, maybe. Or maybe it was a 22-24" barrel and they cut it down and moved the gas block back. Got scared about messing up the hard chrome lining by welding. Edited October 17, 2018 by Mullet Man Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.