kindapointless 22 Posted April 4, 2019 Report Share Posted April 4, 2019 Anyone want to post me up a good side profile of a shotgun hammer? I remember my s12 hammer being different then the tapco and grinding it to the same profile. Trying to reduce some drag Quote Link to post Share on other sites
evlblkwpnz 3,418 Posted April 5, 2019 Report Share Posted April 5, 2019 There isn't enough left on the Tapco G2 to make it like a factory hammer. Factory hammer is a better profile. Quote Link to post Share on other sites
Looter 0 Posted April 27, 2019 Report Share Posted April 27, 2019 So how much grinding is necessary to make a G2 hammer work in a Saiga clone, such as the Lynx? Quote Link to post Share on other sites
evlblkwpnz 3,418 Posted April 28, 2019 Report Share Posted April 28, 2019 As I understand it, there is at least a slight difference from how one might modify one to work in a Saiga or Vepr. CSS sells them specifically modified for Lynx. I haven't gotten to the point in my workload where I'll be doing anything to a Lynx yet. I'm still eyeball deep in Saigas and Veprs. A good start would be to remove your Lynx FCG and compare it to a Tapco G2 FCG. That's usually how I start, by eyeball first and then document relevant measurements taken by calipers. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.