rocketman320 0 Posted November 11, 2022 Report Share Posted November 11, 2022 I have a stock Vepr12. The bolt holds back with a mag installed no issues. The bolt hold button is visible. Once the button is depressed and the bolt closes, the button is no longer visible. When the mag is removed, still no bolt hold button is visible. If I pull the bolt back, the button stays depressed. I’ve seen where the bolt can be locked back without a mag installed by depressing the bolt hold button and pulling the bolt back. My BHB stays depressed so I cannot do this. Am I doing something wrong or is there a fix. Thanks in advance for your help. Quote Link to post Share on other sites
308SAIGA 55 Posted December 30, 2022 Report Share Posted December 30, 2022 Did you modified your hammer? It may be too tight, you might not have taken it down enough, I just finished installing mine and it works great. see my thread here: Quote Link to post Share on other sites
308SAIGA 55 Posted December 30, 2022 Report Share Posted December 30, 2022 (edited) After measuring the hammer width with the BHO it measured approximately 1.163" the BHO measured 0.088" and the trigger about 1.075", I had to take the hammer down about .095" so that it was basically free floating. Edited December 30, 2022 by 308SAIGA Quote Link to post Share on other sites
308SAIGA 55 Posted January 9 Report Share Posted January 9 OK after reading aging your post, what I said above is not right. Do you have any pics of the BHO? Remove cover, spring, charging system and take pics. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.