S12.308NSC 0 Posted February 15, 2008 Report Share Posted February 15, 2008 here's a picture to give you an idea how the set will look on your S12: http://forum.saiga-12.com/index.php?act=at...st&id=14002 this set is for an unmodified S12. the wood is jatoba. it consists of: 1) a quasi-pistol grip target stock with limbsaver recoil pad (pad not pictured) 2) a schnabel sporter style handguard, with vents 3) 3 QD sling studs, one on the stock, 2 on the handguard (for a 3-point sling, or 2-point sling + bipod, etc.) the set is unfinished, so you can finish them however you like. $200 shipped, PM me if you're interested. Link to post Share on other sites
stiletto raggio 20 Posted February 15, 2008 Report Share Posted February 15, 2008 Is the stock designed for use with a scope? The cheek rest looks pretty high. Link to post Share on other sites
S12.308NSC 0 Posted February 16, 2008 Author Report Share Posted February 16, 2008 Is the stock designed for use with a scope? The cheek rest looks pretty high. not particularly, but if you wanted to install a red dot/scope mount it would be good. the irons are pretty high on an S12 as is. if it's too high, you can always sand it down. easier to remove wood than add it. Link to post Share on other sites
BattleRifleG3 16 Posted February 25, 2008 Report Share Posted February 25, 2008 (edited) It may look higher than it is with that photo angle. The height for the cheek rise should be the same as the top of the rear trunion tang. The right side is flat in order to allow a wider (and generally more comfortable) radius for the cheek rest. I was able to find this photo after a quick search. This shows the handguard and buttstock along with a few others. Edited February 25, 2008 by BattleRifleG3 Link to post Share on other sites
S12.308NSC 0 Posted March 4, 2008 Author Report Share Posted March 4, 2008 this has been posted on gunbroker.com, so go there if you wish to purchase. http://gunbroker.com/Auction/ViewItem.asp?Item=93982821 Link to post Share on other sites
Recommended Posts