Shooterman 0 Posted August 15, 2008 Report Share Posted August 15, 2008 Hello all- I'm mid way through my .223 conversion (that is to say, everything is off and out of the receiver), and while the TG and plate removal were not that difficult, my trigger guard's rear hole won't line up with the hole in front of the PG nut hole. Following the Cross-Conn instructions, I cut the end the TG (the 'extra hole') off and am inserting the other end under the mag release shroud, but the rear hole in the TG is a good 1/4-3/8 off from lining up. Should I have to bend the guard to get these holes lined up? Just checking before I proceed. BTW, sorry for no pics, but those of you who've done this should know what I'm talking about/ Thanks for any help. Quote Link to post Share on other sites
nalioth 405 Posted August 15, 2008 Report Share Posted August 15, 2008 They're all like this. Gently bend it, and stick your screw/rivet in the hole. The tension is what keeps you from having to secure the end under the mag catch. Quote Link to post Share on other sites
Shooterman 0 Posted August 15, 2008 Author Report Share Posted August 15, 2008 They're all like this. Gently bend it, and stick your screw/rivet in the hole. The tension is what keeps you from having to secure the end under the mag catch. Hmmm, thought so. Thanks for confirming my suspicions. I'll lean on the sucker til it 'complies.' Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.