brd 1 Posted October 10, 2008 Report Share Posted October 10, 2008 (edited) Setting up to do my S12 conversion.Looking at the drawing on cross-conn http://www.cross-conn.com/Saiga_Conversion/Step_4.htm I notice that the length from the mag well to the rear of the receiver is 5.6",however my S12 is nutz on 6".Where do I put the PG hole?Do I still put it 1.625" from the rear of the receiver? Thanx. Also ,once the plate is removed from the bottom of the receiver how do you keep the safety lever from going all the way down?What are you using for a stop? Edited October 10, 2008 by brd Quote Link to post Share on other sites
cellsworth 21 Posted October 10, 2008 Report Share Posted October 10, 2008 I recommend using the Tromix DIY trigger guard. It will solve all of the problems you mention, and is very easy to use. Quote Link to post Share on other sites
Doc S 0 Posted October 14, 2008 Report Share Posted October 14, 2008 I used a Tromix trigger guard for my S12 conversion. It looks very nice, is extremely easy to do and only took about 1 hour to convert. It would have been less if I had used the Tromix FCG, but I was cheap and used the TAPCO one (having to fit it to make it work). God Bless, Doc S Quote Link to post Share on other sites
bayonet lug 1 Posted October 14, 2008 Report Share Posted October 14, 2008 Setting up to do my S12 conversion.Looking at the drawing on cross-conn http://www.cross-conn.com/Saiga_Conversion/Step_4.htm I notice that the length from the mag well to the rear of the receiver is 5.6",however my S12 is nutz on 6".Where do I put the PG hole?Do I still put it 1.625" from the rear of the receiver? Thanx. Also ,once the plate is removed from the bottom of the receiver how do you keep the safety lever from going all the way down?What are you using for a stop? I THINK you still put it 1.625" from the rear. But I have yet to do a non-DIY trigger guard conversion. As for the safty stop, look at the conversions on gunbroker. Some cut the plate in half keeping the stop where it is. Some move the stop up. Some weld a small bead to stop the lever. Quote Link to post Share on other sites
brd 1 Posted October 14, 2008 Author Report Share Posted October 14, 2008 Setting up to do my S12 conversion.Looking at the drawing on cross-conn http://www.cross-conn.com/Saiga_Conversion/Step_4.htm I notice that the length from the mag well to the rear of the receiver is 5.6",however my S12 is nutz on 6".Where do I put the PG hole?Do I still put it 1.625" from the rear of the receiver? Thanx. Also ,once the plate is removed from the bottom of the receiver how do you keep the safety lever from going all the way down?What are you using for a stop? I THINK you still put it 1.625" from the rear. But I have yet to do a non-DIY trigger guard conversion. As for the safty stop, look at the conversions on gunbroker. Some cut the plate in half keeping the stop where it is. Some move the stop up. Some weld a small bead to stop the lever. Thanx Bayonet lug I have decided to just move the stop forward and reinstall it.As for the placement of the PR hole ,ill measure it all out when my PG nut arrives and let you know where I put the hole. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.