jerrycurlin 0 Posted December 23, 2008 Report Share Posted December 23, 2008 A while back I purchased a converted Saiga from Aim. Conversion done by Tenn guns. I have been getting trigger slap. I called Tenn guns and they said they used a Tapco G3 trigger in their conversions. Any one have this? Any suggestions? Thanks!!! Quote Link to post Share on other sites
22_Shooter 1,560 Posted December 23, 2008 Report Share Posted December 23, 2008 This is the link I was see posted in response to this question: http://www.gunsnet.net/Linx310/slapfix.htm . Other recommendations are to swap out to a Tapco G2, but seeing as how you already have that, I'm not sure. Quote Link to post Share on other sites
nalioth 405 Posted December 23, 2008 Report Share Posted December 23, 2008 My suggestion would be to pull the FCG and see if they actually did use a Tapco model. They might have told you "Tapco" but used a "Century" (or some foreign parts they got mixed in with their US ones). Tennessee Guns is one of those "corner cutting" places that use glue or a line of weld for the bullet guide. Quote Link to post Share on other sites
jerrycurlin 0 Posted December 23, 2008 Author Report Share Posted December 23, 2008 (edited) My suggestion would be to pull the FCG and see if they actually did use a Tapco model. They might have told you "Tapco" but used a "Century" (or some foreign parts they got mixed in with their US ones). Tennessee Guns is one of those "corner cutting" places that use glue or a line of weld for the bullet guide. Good point. I will check. Thanks!!!! They did use a weld bullet guide but works w/ no problems. I appreciate your help. Edited December 23, 2008 by jerrycurlin Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.