weld387 4 Posted February 18, 2011 Report Share Posted February 18, 2011 Great info. I just got a saiga and it came with a Tromix DYI Trigger set in the deal. Have not installed it yet. Luckily I live about 45 miles from Kennasaw Georgia. Would have bummed me out to have too go over a trigger job twice to do it right. It's a bad one that needs to go back. Quote Link to post Share on other sites
fromxtor 20 Posted February 21, 2011 Report Share Posted February 21, 2011 (edited) I still intend on converting my S12 with the tapco FCG, I try to double at the range when I'm qualifying as often as I can. It pisses off the Cadres, if you dont pull the M16 trigger fully to the rear it will do this (double) consistantly. Edited February 21, 2011 by fromxtor Quote Link to post Share on other sites
x_man586 7 Posted March 4, 2011 Report Share Posted March 4, 2011 I am going to look at my WASR. It doubles a lot. I always thought it was because the firing pin was slamming foward with the bolt as the firing pin doesn't have a spring. Quote Link to post Share on other sites
x_man586 7 Posted March 5, 2011 Report Share Posted March 5, 2011 Well I looked at the disconnector, I didn't measure it, but the spring sticks out further than in the picture. So I guess that is not it. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.