jailbait 2 Report post Posted February 22, 2009 So i did the conversion over a year ago. i'm fixing to swap out the safety lever. i have the shepard's crook installed. how do i take my safety off again? Share this post Link to post Share on other sites
Azrial 1,089 Report post Posted February 22, 2009 (edited) So i did the conversion over a year ago. i'm fixing to swap out the safety lever. i have the shepard's crook installed. how do i take my safety off again? Perhaps I am not understanding your question correctly, but yes, to use a new safety (selector) lever, you will have to remove the old one first. If you really are using a Shepherd's crook and not a retainer plate that will have to be removed or pried up to accomplish this. Edited February 22, 2009 by Azrial Share this post Link to post Share on other sites
Big Boss 21 Report post Posted February 22, 2009 To take the safety off, take off the top cover of the rifle and merely pull it up until it is like this : | straight up at a 90 degree angle. Then it should easily pull right out of the hole. Share this post Link to post Share on other sites
cliffevans 2 Report post Posted February 22, 2009 him wont the bolt hold open get in the way if its still in there... Share this post Link to post Share on other sites