Wakko 10 Posted March 31, 2009 Report Share Posted March 31, 2009 My plug clears the barrel, but is really stiff going in. Is it ok to use any lubricant? I know it wasn't recommended on the old one. Quote Link to post Share on other sites
Gunfixr 76 Posted March 31, 2009 Report Share Posted March 31, 2009 I have put lubricant on mine, every once in a while, but most of the time leave it dry. I haven't pitch mic'ed any of the new ones, but if they're following my dimensions, the threads are pretty close. I have seena one or two guns that the threads were tight on, and they get tight sometimes after welding a sight to the gas block. I've also seen one or two where the puck bore was slightly off from the threads, and the end was rubbing, binding since it's a larger diameter than the factory plug. So far all have been fixable by running a tap into the threads. It usually scrapes out a small amount, and all's well. Quote Link to post Share on other sites
Gibbles 23 Posted May 3, 2009 Report Share Posted May 3, 2009 I was thinking about putting some copper anti seize on mine (the same stuff that glocks come with). that stuff is awesome, I use it for sparkplugs and O2 sensors too. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.