cb8180 2 Posted August 26, 2010 Report Share Posted August 26, 2010 I just received my grip from MAA (had DIY grips in stock) and I'm a bit confused on how to mount it to my DIY triggerguard. The grip came with a screw about 2.5 inches long but it's too long to use inside the grip. Can I use a regular AK screw if I shorten it appropriately? Or maybe I could buy a 6mm by 1mm (size of Tromix DIY mount) and trim it to length? I'd really like to be able to use the cap that came with the grip if possible. Sorry if my post is confusing but I really need some advice. Thanks Quote Link to post Share on other sites
cb8180 2 Posted August 28, 2010 Report Share Posted August 28, 2010 Nevermind I got it done (probably made it harder than it needed to be but it works). Got a 6 by 1 by 100 mm bolt, ground the head round, added a slot, and cut about 4mm off the length. Works like a charm! Quote Link to post Share on other sites
Norty 13 Posted October 7, 2010 Report Share Posted October 7, 2010 Are the Pistol Grips without the finger grooves still in the works? 1 Quote Link to post Share on other sites
ACWeller 3 Posted November 15, 2010 Report Share Posted November 15, 2010 Just picked one of these up from CSS. I looooooooooove this grip. Leaps and bounds better than the tapco saw I replaced it with. The tapco had just a little to much play in it. I picked this up with NO expectations but man am I gald I got it. This is the PERFECT pistol grip for any AK/Saiga project. Quote Link to post Share on other sites
doodi1 23 Posted November 16, 2010 Report Share Posted November 16, 2010 I love these grips also. Very comfortable and secure. Quote Link to post Share on other sites
PetesTactical 1 Posted May 25, 2012 Report Share Posted May 25, 2012 No finger groove grip? One to fit Tromix guns? Am I missing something? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.