zenmetsu 17 Posted September 7, 2009 Report Share Posted September 7, 2009 Just a quick question. I cut out the inside of my lower very carefully and it fits like a glove. The problem though is that either my gas block is too far forwards or my lower is a bit too short. There is a little bit of a gap (1.5mm of so) between the back edge of the lower and the front of the receiver when the lower is pushed fully fowards. Because of this, there is a little bit of play with the lower. Is there a way to fix this, or perhaps do you have a few lower retainers which have the bolt hole about an extra 1-1.5mm out? That would fix my problem I think. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.