jsp 1 Posted January 27, 2010 Report Share Posted January 27, 2010 I've been kinda out of the loop sometime so forgive me if this question has been asked before. Has anyone ever used this receiver block? Does ACE make this? I noticed the two bolts on the side. Does it bolt on from the outside of the receiver once the shoulders of the rivets are drilled out and the pistol grip conversion has been done? Does it also bolt from the other side? Quote Link to post Share on other sites
jsp 1 Posted January 27, 2010 Author Report Share Posted January 27, 2010 Link doesn't seem to be working. Let me try here. My link Quote Link to post Share on other sites
dannyfantasy2000 68 Posted January 27, 2010 Report Share Posted January 27, 2010 I've got one in mine. The screws, which are on both sides, go in from the outside of the receiver into the original FCG axis pin holes to anchor it in nice and snug. I like it because it means I don't have four useless holes looking like crap on my gun. I can't weld so it's a nice option. Quote Link to post Share on other sites
Dirt Diver 0 Posted January 27, 2010 Report Share Posted January 27, 2010 The one with the side screws is on my list. My only concern is that, if the reciever block does not fully seat on the back of the reciever, those four little screws will take a beating with the Saiga 12 recoil. Does anyone use this particular block that can attest to fitment. TIA Quote Link to post Share on other sites
dannyfantasy2000 68 Posted January 27, 2010 Report Share Posted January 27, 2010 The one with the side screws is on my list. My only concern is that, if the reciever block does not fully seat on the back of the reciever, those four little screws will take a beating with the Saiga 12 recoil. Does anyone use this particular block that can attest to fitment. TIA Never had a problem with mine. The block is almost completely inside the receiver. It's secured in there from the top with the screw below the guide rod too. If you're particularly concerned about it, would recommend loctite. With 5 screws, along with it being snug along the inside of the receiver, it ain't going anywhere. Quote Link to post Share on other sites
jsp 1 Posted January 28, 2010 Author Report Share Posted January 28, 2010 Is this a modified ACE product or is it a different manufacturer? I know ACE's receiver block has a cut out that secures to the pistol grip nut from the inside. I would use the ACE receiver block but I don't plan to cut out the bottom of my receiver for a pistol grip nut. I will be using a Saigatech or Tac-47 Industries DIY trigger guard for a traditional AK grip. Quote Link to post Share on other sites
sapper1371usmc 107 Posted January 28, 2010 Report Share Posted January 28, 2010 I believe maa makes the receiver block that comes pre drilled for side screws. Also Check out cobra76's diy trigger guard if you want that classic look Quote Link to post Share on other sites
jsp 1 Posted January 28, 2010 Author Report Share Posted January 28, 2010 Thanks! I didn't know Cobra76 made his own DIY trigger guards. I will look into it. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.