aaronjudd 0 Posted February 26, 2010 Report Share Posted February 26, 2010 I just did my converson yesterday and cant get my BHO to fit. When its in the mainspring does not fit on the trigger(or sear) it just slips right off. Do I have to modify it or cut part of it away. If so anyone have any pics. Any help would be greatly appreciated. Also bought tapco gas piston, do i drill it out and do i have to put roll pin back in or can you red loctite? Quote Link to post Share on other sites
CPE1704TKS 24 Posted February 26, 2010 Report Share Posted February 26, 2010 And posting the same question in multiple forums is frowned on. Quote Link to post Share on other sites
aaronjudd 0 Posted February 27, 2010 Author Report Share Posted February 27, 2010 And posting the same question in multiple forums is frowned on. Mikey,Thanks for the heads up, just thought I would reach more people. Quote Link to post Share on other sites
bobsolla 7 Posted March 30, 2010 Report Share Posted March 30, 2010 go to you tube and type in saiga conversion and there are step by step on video.you can use dental floss to pull down through bho hole until you get axis pin in place.that is how i did mine,help to have an extra hand.hope this helps! Quote Link to post Share on other sites
GTwannabe 1 Posted March 31, 2010 Report Share Posted March 31, 2010 A large trash bag twist-tie works better than dental floss. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.