PrecisionAir 0 Posted October 28, 2011 Report Share Posted October 28, 2011 How did you color in the stamped writing on your rifle? Quote Link to post Share on other sites
1liter 20 Posted October 28, 2011 Report Share Posted October 28, 2011 I used a paint pens you can pick up at any craft store, use the ultra thin tips. Others have used crayon with some succes. Quote Link to post Share on other sites
ChileRelleno 7,071 Posted October 30, 2011 Report Share Posted October 30, 2011 I use Testors enamel (modeling paint). This method, done right, almost paints itself. Thoroughly clean & degrease the area. Use a good thinner, thin the paint till it has the viscosity of milk. Then using a micro-tip or very fine tip brush, pick up a drop of paint. Touch the tip into the rollmark (lettering), it should flow right into it and keep going. Repeat, touch tip into rollmark where paint stopped flowing, filling the rollmark completely. There should be very little to no mess. Let dry for a hour or two, then using a cleaning patch, use a little thinner to clean up. Quote Link to post Share on other sites
whitetrashrn 74 Posted October 31, 2011 Report Share Posted October 31, 2011 Same as Chile but used a toothpick. The paint kinda flowed right where it needed to go.. 1 Quote Link to post Share on other sites
icefire 10 Posted November 3, 2011 Report Share Posted November 3, 2011 I tried china markers, crayon, paint pens, then found something that really worked for me. White-out! paint it on, let it dry, then wipe off excess with a bit of gun oil, it stays very well, and is easy and cheap to redo if necccessary, but I haven't had to yet... Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.