heliguy 0 Posted December 27, 2011 Report Share Posted December 27, 2011 Just getting ready to insatll my Dinzag bullet guide for the round trunion & noticed that the screw hole in the guide is off center, is this correct or mis machined? Thanks in advance. Quote Link to post Share on other sites
jr612 0 Posted December 27, 2011 Report Share Posted December 27, 2011 No, that's not correct but I don't see a problem with it. Quote Link to post Share on other sites
baraban7.62 20 Posted December 27, 2011 Report Share Posted December 27, 2011 it is correct, every BG (round trunnion) that i have installed from dinzag had holes not centered, they work fine Quote Link to post Share on other sites
jr612 0 Posted December 27, 2011 Report Share Posted December 27, 2011 Immediately after posting I remembered the round trunnions. Quote Link to post Share on other sites
jaymce 7 Posted December 27, 2011 Report Share Posted December 27, 2011 It is correct. Brian has instructions on his site. Also if you look at a standard AK or pics you will see why the hole is offset. The hole for the BG is drilled in the center / Lowpoint of the trunion. http://www.dinzagarms.com/downloads/bg_install.pdf Quote Link to post Share on other sites
strider12 0 Posted December 28, 2011 Report Share Posted December 28, 2011 Did mine last night, perfect without a hitch!!! Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.