mwrarick 0 Posted January 18, 2012 Report Share Posted January 18, 2012 I live in norfolk, virginia. I recently purchased a Tapco G2 trigger for my saiga 7.62x39 rifle. The problem i have run into is that i have called every gunsmith in the hampton roads area and I was told by every one that they would not install the trigger. If there is anyone on this site that lives in the hampton roads area of virginia who knows how to install a G2 trigger on an ak/saiga, please reply to this. I am willing to compensate for your time. Quote Link to post Share on other sites
Deadeye 325 Posted January 18, 2012 Report Share Posted January 18, 2012 just read in here and watch the vids. do it your self it is easy Quote Link to post Share on other sites
universal_exports 18 Posted January 18, 2012 Report Share Posted January 18, 2012 I done mine in about 15-20 minutes and I had never touched the inside of a trigger before, really straight forward. their are some youtube vids as well. Quote Link to post Share on other sites
SaigaKen 338 Posted January 20, 2012 Report Share Posted January 20, 2012 http://vimeo.com/2787027 Quote Link to post Share on other sites
Stoned_Oli 4 Posted January 20, 2012 Report Share Posted January 20, 2012 I agree, it is very easy. The only difficult part is removing the disconnector spring from the old trigger group without shooting it , but a new spring is usually $1. Don't forget to buy an axis pin retainer plate as well since the original spring will not work on the new FCG, and I had to remove a little bit of material from the safety lever tab to get it to clear the disconnector for installation after the trigger group waws in place. Just watch the videos on youtube. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.