sjglaw 1 Posted February 6, 2012 Report Share Posted February 6, 2012 The front quadrail retainer where the three screws are, does not fit tightly around the circumference of the tube. I guess it is either a tolerence issue with the tube or where the holes are drilled on the front retainer for the hex screws. How can this problem be resolved? The result is that there is some play/movement in the front handguard. Steve Quote Link to post Share on other sites
cvhanh20 1,052 Posted February 6, 2012 Report Share Posted February 6, 2012 There is a jack screw on the bottom front and back to counter this issue. You'll find your info here: http://www.chaosus.com/saiga_762_pdf.pdf Quote Link to post Share on other sites
sjglaw 1 Posted February 6, 2012 Author Report Share Posted February 6, 2012 in the diagram, which one is the jack screw, for the front and for the back? Quote Link to post Share on other sites
cvhanh20 1,052 Posted February 6, 2012 Report Share Posted February 6, 2012 Number 6, just tighten them snug against the bottom of the barrel. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.