crankywanker 7 Posted March 30, 2012 Report Share Posted March 30, 2012 Trying to clean my Saiga but the puck won't pop out. Suggestions on how to get it out? Quote Link to post Share on other sites
poolingmyignorance 2,191 Posted March 30, 2012 Report Share Posted March 30, 2012 Spray/pour some hoppes solvent in there, wait 10 min, then use a cleaning rod to tapp it out from the other end. 2 Quote Link to post Share on other sites
RED333 1,025 Posted March 30, 2012 Report Share Posted March 30, 2012 Spray/pour some hoppes solvent in there, wait 10 min, then use a cleaning rod to tapp it out from the other end. +1 Quote Link to post Share on other sites
poolingmyignorance 2,191 Posted March 31, 2012 Report Share Posted March 31, 2012 Once you get that thing outta there, some hoppes on a scotch brite pad and a little elbow grease will get it looking good as new. 1 Quote Link to post Share on other sites
The_Caged_Bird 474 Posted March 31, 2012 Report Share Posted March 31, 2012 Whack it! 2 Quote Link to post Share on other sites
one2za 7 Posted March 31, 2012 Report Share Posted March 31, 2012 I tap it out with a chopstick. Quote Link to post Share on other sites
ewoketeer 35 Posted March 31, 2012 Report Share Posted March 31, 2012 I tap it out with a chopstick. Must be one helluva chopstick!! Quote Link to post Share on other sites
incognito485 26 Posted March 31, 2012 Report Share Posted March 31, 2012 Run a brass cleaning rod through the gas tube and tap it out if it won't loosen up. 1 Quote Link to post Share on other sites
ramlake 98 Posted April 1, 2012 Report Share Posted April 1, 2012 Wood dowel Quote Link to post Share on other sites
kresk 10,063 Posted April 1, 2012 Report Share Posted April 1, 2012 Wood dowel +1 Quote Link to post Share on other sites
crankywanker 7 Posted April 2, 2012 Author Report Share Posted April 2, 2012 Is there any which way it goes back in? or does it not matter? Quote Link to post Share on other sites
Guns Are Great 140 Posted April 2, 2012 Report Share Posted April 2, 2012 not for factory puck, it just goes in. the mdarms, css, etc... are directional. Quote Link to post Share on other sites
gunfun 3,931 Posted April 2, 2012 Report Share Posted April 2, 2012 If it is the factory, it doesn't matter. There will be marks from the operating rod on one side though. 1 Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.