Kylsix 2 Posted April 9, 2012 Report Share Posted April 9, 2012 I recently converted my Saiga, but I have a problem in that the hammer spring is too long. It does not rest on the trigger like it should, one arm of the spring does, but it blocks the safety from functioning, and the other arm of the spring doesn't rest on anything, but would rest on the bottom of the receiver if it were touching. This is the OEM spring, I made no changes to it, and verified several times, even had a buddy check, that the right amount of coils were in the spring and that everything is properly mounted. I am wary of modifying the spring without full knowledge of how it should look/work. Also, are there any springs that can be purchased that are already set to work on a converted Saiga? Thanks, Quote Link to post Share on other sites
RED333 1,025 Posted April 9, 2012 Report Share Posted April 9, 2012 Something aint right, can you post a pic from the top of the reciver looking down in? Hammer cocked and uncoked. Quote Link to post Share on other sites
Kylsix 2 Posted April 9, 2012 Author Report Share Posted April 9, 2012 Will take some pics when I get home. Quote Link to post Share on other sites
gpqueen 545 Posted April 9, 2012 Report Share Posted April 9, 2012 Sounds like you have a defective trigger. Tapco has sent a few out that had a bad cast and missing one of the back sections where the main springs arms rest. They should be even. 1 Quote Link to post Share on other sites
The_Caged_Bird 474 Posted April 10, 2012 Report Share Posted April 10, 2012 I KNEW it was something else, there was no way that his spring legs were too long! Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.