chaps2 0 Posted March 10, 2004 Report Share Posted March 10, 2004 i just finshed my convert, but was wondering other options for the aluminium binding post for a home hobby guy, they seem very soft and would like steel Quote Link to post Share on other sites
thinking 1 Posted March 13, 2004 Report Share Posted March 13, 2004 Hi I just finished up yesterday. I ended up reusing the revits. When I drilled them out, I was careful enough to have the revits still long enough the reach through flush to the other side. I then drilled a small hole in the end of the revit. I then took a nail and sized the shaft to be a press fit in the revit hole. Some loctite and a few taps with a hammer and I was done. Quote Link to post Share on other sites
Bigfoot Wallace 0 Posted March 13, 2004 Report Share Posted March 13, 2004 Check with ace hardware they sell brass binding posts.(better than Al) Look at an auto parts store for clips and pins they may have something. Quote Link to post Share on other sites
Tengu 0 Posted April 6, 2004 Report Share Posted April 6, 2004 (edited) If you just want to fill the holes left by removing the Saiga trigger, 1/8 inch X 1/8 inch pop rivets with thin backup washers on the inside will fill the holes. The pop rivets will not stay in the holes without the washers. I think flat washers for 4-40 size screws is what I used. If you want to make sure you have correct size, take a pop rivet to the hardware store with you. Edited April 6, 2004 by Tengu Quote Link to post Share on other sites
MRW 0 Posted April 9, 2004 Report Share Posted April 9, 2004 I used black button head screws with a hex head threaded into a nut on the inside of the reciever. Quote Link to post Share on other sites
NedPepper 0 Posted April 9, 2004 Report Share Posted April 9, 2004 Gun Porn Gun Porn Gun Porn! I'd like to see some pics please. I used button heads with nuts at first but then began to wonder if the reciever needed the structural support that I took away so I went to Ace hardware and found some threaded posts. Quote Link to post Share on other sites
flejl 0 Posted April 10, 2004 Report Share Posted April 10, 2004 Great idea on the threaded posts. What type of metal are they? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.