CSeaBass 0 Posted July 25, 2012 Report Share Posted July 25, 2012 I know there are triggers already modified available. I was wondering what they do to them? Profile the hammer face and cut the hammer to allow use of the BHO? Can I get away with an unmodified g2 hammer if I intend to leave the BHO out of this project? Also in regards the profiling the hammer, I assume it's a combination of reliability(rounding the face itself) and clearence(removing the "bulb" at the base). Is this correct? Thank you Quote Link to post Share on other sites
corbin 621 Posted July 25, 2012 Report Share Posted July 25, 2012 Welcome to the forum. Correct. If you plan on not using a BHO, you'll still have to remove material at the base, and contour the face. Quote Link to post Share on other sites
CSeaBass 0 Posted July 25, 2012 Author Report Share Posted July 25, 2012 thank you for the response Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.