ffrogg 0 Posted October 6, 2005 Report Share Posted October 6, 2005 almost done! just need to figure out how to keep the pins n place for trigger group and hammer. anyone use the retaining spring or does anyone have any better ideas i tried the way on the conversion website but couldnt seem ti get it to work right any ideas Quote Link to post Share on other sites
k_dawg 0 Posted October 6, 2005 Report Share Posted October 6, 2005 this is what I use. It's great http://www.blackjackbuffers.com/index.php?...601f33274880a77 Quote Link to post Share on other sites
hoop762 0 Posted October 7, 2005 Report Share Posted October 7, 2005 i used e-clips in my conversion. I would agree the retaining plate is probably the best way to go, but a pair of e-clip are like 25 cents at lowes, so....yeah im cheap, but they work great for me Quote Link to post Share on other sites
ffrogg 0 Posted October 7, 2005 Author Report Share Posted October 7, 2005 i put in e clips last night they seemto hold ok the hammer pin still moves but not very much that should be ok right? Quote Link to post Share on other sites
jtoddellis 2 Posted October 7, 2005 Report Share Posted October 7, 2005 on both of my conversions I had room to put 2 eclips on each pin. That took out the remaining slack. Quote Link to post Share on other sites
hoop762 0 Posted October 7, 2005 Report Share Posted October 7, 2005 i put in e clips last night they seemto hold ok the hammer pin still moves but not very much that should be ok right? <{POST_SNAPBACK}> yeah man, my pin moves just the slightest bit, but has not caused me any problems at all. Ive got about 4 thousand rounds through my conversion and it runs like a champ Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.