ST19AG_WGreymon 0 Posted September 13, 2012 Report Share Posted September 13, 2012 Is it feasible to remove the stock FSB and GB and install a new set using a rubber mallet? Quote Link to post Share on other sites
thebuns1 4,323 Posted September 14, 2012 Report Share Posted September 14, 2012 Ive done it and so have many others on here. Removal may be a bitch. It'd be easier and faster to cut it with a dremel or other cutting tool. Installation isnt that bad and the mallet will be able to index them fairly good. Just throw some anti seize on there prior to reinstallation. There are several threads on this topic on this forum that will go into more detail. Id suggest using the search function. Quote Link to post Share on other sites
Agent Lemon 157 Posted September 14, 2012 Report Share Posted September 14, 2012 Of course. Well, actually, I don't know about taking them OFF with a rubber mallet, but putting them on, yes. 1 Quote Link to post Share on other sites
thebuns1 4,323 Posted September 14, 2012 Report Share Posted September 14, 2012 Yeah I didnt mean take them off with a mallet. That would be a task. Quote Link to post Share on other sites
ST19AG_WGreymon 0 Posted September 14, 2012 Author Report Share Posted September 14, 2012 Thanks guys. I was going to dremel the old FSB and GB off. Quote Link to post Share on other sites
devilfish13 6 Posted October 11, 2012 Report Share Posted October 11, 2012 I used a die grinder, came off easy without too much marring... just be careful not to cut too deep... Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.