Grau_Tek 0 Posted October 28, 2005 Report Share Posted October 28, 2005 hi there got this BG in the mail the other day.... i realize that it must be modded for the 762 saiga any hints or suggestions for mods and also proper way to drill hole for rivet and seat it? instead of cutting bg for the rivet that sticks thru the left side of the trunnion, is it ok or possible to shave it off? on the amd 65 i have this rivet is nonexistent also it does not look like there is a rivet holding the BG in at all anybody? Quote Link to post Share on other sites
jtoddellis 2 Posted October 28, 2005 Report Share Posted October 28, 2005 Yo will have to smooth out the bottom of the BG. will be too tall to slip under your barrel. I would not shave down the rivit. It is easy enough just to cut the BG. I used that particular Bullet Guide on my 7.62x39, but If I do another one I will use a piece of pipe like in the Sheiks Conversion. http://www.cross-conn.com/Saiga_Conversion/index.htm Quote Link to post Share on other sites
Crosshair 1 Posted October 30, 2005 Report Share Posted October 30, 2005 Dremel it until it fits. I just used a piece of pipe to make mine. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.