Spetnaz Soldier 47 Posted January 4, 2013 Report Share Posted January 4, 2013 Hey guys had a question. I'm wondering if the firing pin should be struck flush by the hammer or should the hammer sit flush on the bolt. My hammer strikes the pin flush but seats on the bolt at a very slight angle. Its kinda causing the end of the bolt to mash just a little bit. Dont think its serious but you never know. Quote Link to post Share on other sites
thebuns1 4,323 Posted January 4, 2013 Report Share Posted January 4, 2013 (edited) I dont think the hammer hits the bolt hard enough to mushroom it too much. Just MO. I wouldnt worry too much about it, unless you notice it getting worse. Edited January 4, 2013 by Captain Hero Quote Link to post Share on other sites
Spetnaz Soldier 47 Posted January 4, 2013 Author Report Share Posted January 4, 2013 Ok thanks a lot Hero you always have good advice. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.