Kss_Waylander 0 Posted January 20, 2013 Report Share Posted January 20, 2013 I have mine all installed. No issues with installation, but I do notice that my top "monolithic" rail is not level. It is higher right in the middle at the hinge. The front sight is gone and I have no clearance issues underneath whatsoever. Is it a big deal? Any suggestions? Quote Link to post Share on other sites
Brian76 11 Posted January 20, 2013 Report Share Posted January 20, 2013 Did you remove the rear sight? Quote Link to post Share on other sites
Kss_Waylander 0 Posted January 21, 2013 Author Report Share Posted January 21, 2013 Yes, I have total clearance underneath all the way down. Quote Link to post Share on other sites
dustindu4 101 Posted January 21, 2013 Report Share Posted January 21, 2013 Mine does that too Quote Link to post Share on other sites
mman 0 Posted January 21, 2013 Report Share Posted January 21, 2013 My sights would go off all the time with the titan. I switched to the extended quad which is a single piece on the top. No more problems. Quote Link to post Share on other sites
KTM 72 Posted January 22, 2013 Report Share Posted January 22, 2013 My Titan did the same thing. Did a bit of filing to the notch on the Titans backplate so it could ride higher on the recoil spring button. A few extra turns on the set screw and that straightened her right up. I've been a lot poaching info from this site for awhile, finally signed up today. 1st post. Anyway I hope this helps you out Quote Link to post Share on other sites
Kss_Waylander 0 Posted January 22, 2013 Author Report Share Posted January 22, 2013 What if I file away material on the bottom section near where to hex bolt attaches it to the gas block? That would in theory raise up the front of the rail and level it out? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.